Description
ORIENTAL AZD-CEP
Driver Type |
EtherNet/IP Compatible |
Power Supply |
Single-Phase/Three-Phase 200-240 VAC |
Control Power Supply |
24 VDC ±5%, 0.25 A (0.5 A for Electromagnetic Brake) |
Interface – Pulse Input |
2 points, Photocoupler Maximum input pulse frequency Scanner provides line driver output: 1 MHz (50% duty) Scanner provides open collector output:250 kHz (50% duty) |
Interface – Control Input |
6 points, Photocoupler |
Interface – Pulse Output |
2 points, Line driver |
Interface – Control Output |
6 points, Photocoupler/Open collector |
Interface – Power Shut Down Signal Input |
2 points, Photocoupler |
Interface – Power Shut Down Monitor Output |
1 point, Photocoupler/Open collector |
Interface – Field Network |
EtherNet/IP |
Degree of Protection |
IP10 |
Insulation Resistance (Driver) |
When a 500 VDC megger is applied to the following locations, resistance is 100MΩ or higher. Between the PE terminal and main power supply terminal Between the encoder connector and main power supply terminal Between the input signal terminal and main power supply terminal. |
Dielectric Strength (Driver) |
No abnormalities are observed when the specified voltages are applied for 1 minute Between the protective earth terminal and main power supply 1.5 kVAC 50/60 HZ Between the encoder connector and the mian power supply terminal 1.8 kVAC 50/60 Hz Between the input signal terminal and main power supply terminal 1.8 kVAC 50/60 Hz |
Ambient Temperature Range |
0ºC ~ +55ºC (+32ºF ~ +131ºF) (nonfreezing) |
Ambient Humidity |
85% max. (noncondensing) |
Operating Atmosphere |
No corrosive gases or dust. Cannot be used in radioactive area, magnetic field, vacuum or other special environment. |
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
ORIENTAL AZD-CEP
Reviews
There are no reviews yet.